(FOR HIGHLANDS AND ISLANDS CONTACT US FOR A QUOTE)
BENEFITS AND KEY FEATURES
Ready to use, water based
Anti-slip
Provides a penetrating durable satin finish
Oil and stain resistant
UV stable
Enhances colour
Inhibits algae, moss and lichen growth
PRODUCT DESCRIPTION
Summit Coatings Paverseal (SATIN) ANTI-SLIP Paving Sealer is manufactured using premium grade acrylic resins.
Manufactured at a facility operating ISO 9001 QMS system to ensure consistent quality.
Used worldwide by trade professionals
Summit Coatings Paverseal (SATIN) ANTI-SLIP water based sealer penetrates deep into the surface protecting it from ingress of water, oil and dirt.
Suitable for – Domestic driveways and commercial car parks.
USES AND SURFACE COMPATIBILITY
Also suitable for use on pattern imprinted concrete, brickwork and indian stone.
COVERAGE RATE
This is a rough estimate and varies depending on the porosity of the substrate and the application method.
4m2 per litre approximately for first coat
6m2 per litre for approximately second coat
DRYING TIME
Under normal conditions, it is touch dry in approximately 3-4 hours.
Leave 24hrs before applying 2 nd
coat.
Do not drive on the surface for 24 hours, after the last coat.
APPLICATION
Make sure the surface is 100% dry and free from any pooled water or contaminants before application. Do not apply if there is any chance of rain.
Apply using Brush, Roller, or Sprayer.
Be careful when going over grout lines for best results, use a dry brush to remove excess sealer out of grout lines do not leave pooled.
STORAGE PRECAUTIONS
Store away from frost. Secure the lid between uses.
THINNERS
Thinners are not required with this product, use water for cleaning sprayers and brushes.
SURFACE PREPARATION
Ensure all surfaces to be sealed are clean, dry and free from oil and grease and there are a couple of days of good weather so there is no chance of rain during application.
Health & Safety: Wear suitable clothing, gloves and eye protection.
Notice:Summit Coatings only obligation shall be to replace such quantity of product proved to be defective.
User shall determine the suitability in connection therewith. Since the product is used under conditions beyond the control of the manufacturer, these materials must be used strictly in accordance with the manufacturer’s instructions.
