Sealer dissolving solution used on pattern imprinted concrete, block paving, Indian stone to dissolve acrylic sealers
Problem with the sealer on your driveway?
Sealer, peeling or flaking us dissolving solution to remove the sealer
Solvent based sealants may "bloom" should damp or moisture be present before full cure has taken place. Solvents are released through the cure that normally permeate through the sealer, however if the sealant is applied too thickly, the substrate is damp or cold, blooming may occur, giving the appearance of milky white or silvery cloud effect, this may look patchy, spotty in certain areas or across the whole driveway or patio
The surface must be completely dry. DO NOT USE IF RAIN IS IMMINENT. Do not apply in temperatures below 5°C or above 25°C. The product should not be subjected to extreme temperatures until completely dry. Apply using a soft broom. The surface should be dry in 2-4 hours. Do not traffic for 24-48 hours after application. Treats approx' 4m² per litre. This product should be used without thinning down. Ensure that all traces of "blooming" have gone before resealing.
(Work is currently being done on this page, please excuse any errors)
